j runner help

Discussion in 'Xbox 360 Support' started by ItzEV0_YT, Jul 11, 2018 at 8:16 PM with 2 replies and 57 views.

  1. ItzEV0_YT

    ItzEV0_YT Newbie

    Messages:
    2
    Ratings:
    0
    I was soldering my jr programmer v2 wires to my Xbox 360 phat jasper motherboard to RGH the system with a butane soldering iron which blows a lot of heat out and I noticed 3 white dots appeared on a chip that says HYNIX on top and now my console will not start.
    When I attempt to start it nothing happens no changes in my power supply light and no lights on my ring of light board turn on I spent a lot of time on google looking for this and I cant find anything. I have tried desoldering my j runner wires and made sure their were no bridges but still no luck.

     
  2. rynax

    rynax Newbie

    Messages:
    90
    Ratings:
    6
    You want to find a multi-meter to check the motherboard for defects/damages.
    I'd opt for USB PIC18F based nand flasher/CPLD programmer , instead of the JR programmer v2, and save the money toward a good soldering iron
     
  3. OP
    ItzEV0_YT

    ItzEV0_YT Newbie

    Messages:
    2
    Ratings:
    0
    ok thanks